Whirlpool Cabrio Dryer Won't Start Says Sensing. My whirlpool cabrio dryer won't start. The sensor is located on the back of the dryer, and it can be reset by unplugging the power cord from the dryer.
You need to make sure that your washing machine is in standby mode. Hold on for 30 minutes for the appliance to cool and then reconnect the power. Whirlpool duet dryer wont start says sensing;
Table of Contents
As Your Load Of Laundry Tumbles In The Drum, It Makes Contact With The Sensor Strips So That The Dryer Can End The Cycle When Your Laundry Is Dry.
That is, your washing machine must be turned on with all the off mode indicators. Make sure the dryer is in standby mode, plugged in, and all the indicators off. You need to make sure that your washing machine is in standby mode.
Washer Machine In Standby Mode.
We have had a repair man out twice because initially it did. If the thermo fuse is not bad check the door switch. To check the thermo fuse use an ohmmeter to check for continuity across the terminals with the dryer unplugged and the wires off the thermo fuse.
To Perform A General Reset On Your Whirlpool Dryer, Disconnect The Power Supply To Your Dryer By Unplugging.
The excessive lint inside the drum shows that the lint is not being drawn into your dryer filter because of the poor circulation of air. Push power , select cycle and when i push start, it just stays on sensing. Open the dryer door and check if the light inside the dryer turns on.
Then I Hear A Click, The Sensing Light Comes On.
Couldn't get any codes to come up eith. One of the features of the duet series of dryers is automatic dryness sensing. There are several common situations whereby a whirlpool cabrio dryer will not start.
When Your New Whirlpool Washer Stuck On Sensing, Then You Need To Do The Following:
My whirlpool cabrio dryer won't start. The lights come on, i press start. First, let's rule out a power issue.