close
close

How To Light A Gas Fireplace Pilot

How To Light A Gas Fireplace Pilot

How To Light A Gas Fireplace Pilot. Once you have taken off the facing of the gas fireplace, you should see the gas controls. If there are issues with the fireplace and its pilot light, you will notice the blue tip not being there.

How To Light A Gas Fireplace Pilot
How to light the pilot on a gas fireplace YouTube from www.youtube.com

The main burner releases gas when the appliance is switched on, and the pilot light ignites the gas. Turn the dial from the ‘off’ position to the ‘pilot’ position. Once you have given any excess gas a chance to dissipate, follow the instructions in your system’s manual to relight the pilot.

Gas Fireplaces Have The System Of Ignition Based On The Pilot Light Stand That Provides Flame And The Thermocouple That Sends An Electric Signal For The Gas Valve.

Most gas or propane fireplaces have a decorative cover. The first think you want to do is pull the cover off the fireplace. Push the igniter button once every second until it lights.

Read And Follow The Instructions That Came With You.

Within the controls, as part of the ignition system, will be your pilot light. Depending on how long it’s been since the gas fireplace was last used, ignition may take multiple attempts. The flame should remain lit after releasing the button.

It Uses A Small Amount Of Natural Gas At All Times, Which Means You Do Not Need To Use It Often Or Wait For The System To Warm Up Before Turning On Your Fireplace.

Often, this will involve manually depressing the pilot valve and using an electric ignitor or match to light the pilot. When the pilot is on, the flame gives the right temperature to the thermocouple sensors and in its turn, the thermocouple gives the signal. Keep a close eye on your pilot light once you have restored the flame.

What Is A Gas Fireplace Pilot Light?

These should be toward the bottom of the unit and. The procedure commonly followed for lighting a gas fireplace with a dial and separate spark ignitor button can be: The pilot burner could also be behind a small panel.

Press And Hold Down The Gas Control Knob, Then Press The Igniter Button Multiple Times, As Needed, Until The Pilot Flame Ignites.

Depending on how long it’s been since the gas fireplace was last used, ignition may take several attempts before igniting. The main burner releases gas when the appliance is switched on, and the pilot light ignites the gas. A pilot light is an ignition source used to ignite gas for your fireplace.

About the Author

Leave a Reply

Your email address will not be published.

You may also like these